• <tr id='De2bgA'><strong id='De2bgA'></strong><small id='De2bgA'></small><button id='De2bgA'></button><li id='De2bgA'><noscript id='De2bgA'><big id='De2bgA'></big><dt id='De2bgA'></dt></noscript></li></tr><ol id='De2bgA'><option id='De2bgA'><table id='De2bgA'><blockquote id='De2bgA'><tbody id='De2bgA'></tbody></blockquote></table></option></ol><u id='De2bgA'></u><kbd id='De2bgA'><kbd id='De2bgA'></kbd></kbd>

    <code id='De2bgA'><strong id='De2bgA'></strong></code>

    <fieldset id='De2bgA'></fieldset>
          <span id='De2bgA'></span>

              <ins id='De2bgA'></ins>
              <acronym id='De2bgA'><em id='De2bgA'></em><td id='De2bgA'><div id='De2bgA'></div></td></acronym><address id='De2bgA'><big id='De2bgA'><big id='De2bgA'></big><legend id='De2bgA'></legend></big></address>

              <i id='De2bgA'><div id='De2bgA'><ins id='De2bgA'></ins></div></i>
              <i id='De2bgA'></i>
            1. <dl id='De2bgA'></dl>
              1. <blockquote id='De2bgA'><q id='De2bgA'><noscript id='De2bgA'></noscript><dt id='De2bgA'></dt></q></blockquote><noframes id='De2bgA'><i id='De2bgA'></i>





                QQ:2355823135 QQ:2355823134

                当前位置 : 网站首页 / 新闻资讯



                • 10bet平台常见故障及维修你知道多少?
                • 本站编辑:10bet平台发布日期:2019-05-28 21:56 浏览次数:


                After long-term use of kitchen lampblack purifier, many restaurants find that the purifying effect will be reduced, leading to lampblack can not be well purified, and there will be a variety of strikes at work. Why? Today, with you to learn about kitchen lampblack purifier common failures and maintenance-related knowledge, respectively, as follows:



                Firstly, the heat of the motor is severe: the stator winding is partly short-circuited; the oil bearing is severely short of oil, so it should be cleaned and repaired in time to restore the purification effect.


                Second, the key switch is insensitive: motor torque decreases, speed slows, should be replaced with the same specifications of capacitors; should repair or replace short-circuit windings.

                第三,润滑不良发热及处理办法:要适量↑加油,若〖轴承毁坏,应更换轴承:各档琴键开关能锁住,机∑ 械功能良好,但不可以启动电机,应检查各档开关的公共连线是不是断路,若断路应修复;若其中某档按下电机不可以运转,别的♀档正常,应检查失控的那一档是不是触点毁坏或连ぷ线脱落;按下开关电机能运转,松开后锁不住【,检查锁不住的那一档开关导电弹簧与导电片是不是接触不◤上,或开关弹簧片脱落,位移.应调整弹簧片或■更换开关;两档同时被锁住.应检查互〗锁弹簧是不是位移、变形,若是应调整、修理互锁弹簧.

                Third, bad lubrication, heating and treatment methods: to properly refuel, if the bearings are damaged, the bearings should be replaced: each key switch can be locked, the mechanical function is good, but can not start the motor, should check whether the public connection of each switch is broken, if the break should be repaired; if one of the gears is not able to operate, the other gears are normal, should check whether the out-of-control gear is damaged or not. Or the connection will fall off; if the switch motor can run, it will not lock after loosening, check whether the conductive spring of the switch that cannot be locked can not contact with the conductive sheet, or the spring sheet of the switch will fall off and displace. The spring sheet should be adjusted or the switch should be replaced; the two gears should be locked at the same time. The displacement and deformation of the interlocking spring should be checked, and if the interlocking spring should be adjusted and repaired.


                Fourth, oil leakage of fume purifier: improper installation and insufficient elevation angle. It is necessary to re-install the suction oil so that it can flow smoothly into the oil collecting tank; the oil draining pipe falls off or breaks down, and the sealing strip of the oil collecting box is damaged. The oil draining pipe should be re-inserted when it falls off, and the damaged oil pipeline and sealing strip should be replaced.


                Fifth, fume purifier leakage: power cord, motor winding insulation damage and encrustation, should be wrapped up or new wires, new windings; components moisture intake, should find out the cause of water intake, if the flue gas pipe is not properly installed, should be re-installed, the outlet slightly bent down to avoid rainwater into the machine; components accumulated too much dirt, insulation reduced. Dirt should be cleaned and used after drying treatment.